BHQNH - U-1201D EPOXY PRIMER COMP A

  • MSDS: BHQNH
  • Manufacturer: STERLING LACQUER MFG CO INC
  • Product Name: U-1201D EPOXY PRIMER COMP A
  • National Stock Number: 8010-00-935-7080
Product Identification

Product ID:U-1201D EPOXY PRIMER COMP A
MSDS Date:04/10/1986
FSC:8010
NIIN:00-935-7080
Kit Part:Y
MSDS Number: BHQNH

Responsible Party
STERLING LACQUER MFG. CO. INC.
3150 BRANNON AVE.
ST. LOUIS, MO 63139
US

Emergency Phone: 314-776-4450

Info Phone: 314-776-4450

Preparer: P. D. MOORE

Cage: 60003

Contractor
STERLING LACQUER MFG CO
ST. LOUIS, MO 63139-1422 US

Telephone: 314-776-4450

Cage: 60003

Ingredients

TOLUENE (SARA III)

CAS: 108-88-3

RTECS: XS5250000

Fraction By Weight: 10 - 30%

OSHA PEL 200 PPM/150 STEL

ACGIH TLV: 50 PPM; 9293

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS


CHROMATE

Fraction By Weight: 9.34%

ACGIH TLV: .10 MG/M3


N-PROPYL ACETATE

CAS: 109-60-4

RTECS: AJ3675000

Fraction By Weight: 20%

OSHA PEL 200 PPM/250 STEL

ACGIH TLV: 200 PPM/250STEL;9192


DIACETONE ALCOHOL

CAS: 123-42-2

RTECS: HI5600000

Fraction By Weight: 10%

OSHA PEL 50 PPM

Hazards

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Health Hazards Acute and Chronic:CAN CAUSE SEVERE EYE IRRITATION,
REDNESS, TEARING, BLURRED VISION. PROLONGED SKIN CONTACT CAN
CAUSE MODERATE IRRITATION, DERMATITIS. EXCESSIVE INHALATION
CANCAUSE NASAL/RESPIRATORY IRRITATION. ASPI RATION INTO LUNGS CAN
CAUSE CHEMICALPNEUMONITIS WHICH CAN BE FATAL.
Effects of Overexposure:EYE: SEVERE IRRITATION, REDNESS, TEARING, AND
BLURRED VISION SKIN: CAN CAUSE MODERATE
IRRITATION, AND DERMATITIS INHAL: CAN
CAUSE NASAL AND RESPIRATORY I RRITATIONINGST: ASPIRATION INTO LUNGS
CAN CAUSE CHEMICAL PNEUMONITIS WHICH CAN BE FATAL.
Medical Cond Aggravated by Exposure:OVER 400PPM MAY CAUSE INJURY TO
BONE MARROW, BLOODCELLS, KIDNEY, AND LIVER.

First Aid

First Aid:EYE: FLUSH WITH WATER FOR 15 MINUTES GET MEDICAL ATTENTION
SKIN: WASH WITH SOAP AND WATER
INHAL: REMOVE TO FRESH AIR IF
DISCOMFORT PERSISTS TAKE TO PHYSICIANINGST: DO NOT INDUCE VOMITING
GET MEDICAL ATTENTION

Fire Fighting

Flash Point:45F/7C
Lower Limits:1.1
Extinguishing Media:FOAM, CO2, DRY CHEMICAL
Fire Fighting Procedures:WEAR SCBA WITH FULL FACEPIECE OPERATED IN
PRESSURE DEMAND WHEN FIGHTING FIRES. USE WATER FOG NOZZLES TO COOL
CLOSED DRUM.
Unusual Fire/Explosion Hazard:KEEP AWAY FROM HEAT & OPEN FLAME. VAPORS
ARE >AIR. REMOVE ALL SOURCES OF IGNI- TION. RESIDUE CAN IGNITE
EXPLOSIVELY. NEVER USE WELDING/CUTTING TORCH ON DRUM.

Accidental Release

Spill Release Procedures:WEAR RESPIRATOR. ABSORB WITH VERMICULITE OR
OTHER ABSORBENT MATERIAL. ELIMINATE ALL SOURCES OF IGNI-TION. STOP
SPILL AT SOURCE PREVENT SPREADING.

Handling

Handling and Storage Precautions:STORE IN DRY AREA, BELOW 120F. KEEP
CONTAINERS TIGHTLY CLOSED. PROTECT FROM PHYSICAL DAMAGE.
EMPTIED CONTAINERS RETAIN PRODUCT RESIDUES.

Exposure Controls

Respiratory Protection:A NIOSH/MSHA APPROVED AIR SUPPLIED RESPIRATOR IS
ADVISED IN ABSENCE OF PROPER ENVIORNMENTAL CONTROL. OSHA
REGULATIONS ALSO PERMIT OTHER NIOSH/MSHA RESPIRATORSUNDER SPECIFIED
CONDITIONS.
Ventilation:PROVIDE SUFFICIENT MECHANICAL AND/OR LOCAL EXHAUST VENTILA-
TION TO MAINTAIN EXPOSURE BELOW TLV
Protective Gloves:RESISTANT GLOVES
Eye Protection:CHEMICAL SPLASH GOGGLES/SAFETY GLASSES
Other Protective Equipment:IMPERVIOUS CLOTHING AND BOOTS
Work Hygienic Practices:WASH WITH SOAP AND WATER AFTER USE BEFORE
EATING OR SMOKING.LAUNDER CONTAMINATED CLOTHING BEFORE REUSE
Supplemental Safety and Health
IN LABORATORY INHALATION STUDIES, BIRTH DEFECTS, INCREASED FETAL
LETHALITY, AND DELAYED FETAL DEVELOPMENT HAVE BEEN OBSERVED IN
OFFSPRING OF FEMALE ANIMALS EXPOSED DURING PREGNANCY, WITH A
THRESHO LD RESPONSE LEVEL IN THE RANGE OF 150 TO250 PPM
CONCENTRATION IN THE AIR.

Chemical Properties

HCC:F3
Boiling Pt:B.P. Text:>100F
Vapor Density:>AIR
Evaporation Rate & Reference:SLOWER THAN ETHER
Percent Volatiles by Volume:59.11

Stability

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG OXIDIZING AGENTS
Stability Condition to Avoid:EXCESSIVE HEAT
Hazardous Decomposition Products:BURNING CAN PRODUCE CARBON
DIOXIDE/MONOXIDE

Disposal

Waste Disposal Methods:DESTROY BY LIQUID INCINERATION. CONTAMINATED
ABSORBENT MAY BE DEPOSITED IN A LANDFILL IN ACCORDANCE WITH
FEDERAL, STATE, AND LOCAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.